| RATING |
| Voltage | | 20V |
| Current | | 3A |
| PRACTICAL TEMPERATURE RANGE |
| Usage Temperature Range | Within -30C to +80C | -30~80C |
| STANDARD ATMOSPHERIC CONDITIONS |
| Temperature | For measurements and tests | 5C to 35 |
| Humidity | For measurements and tests | 45% to 85% |
| Pressure | For measurements and tests | 86Kpa to 106Kpa |
| MECHANICAL |
| Connection Force | After connecting and disconnecting using standard plug gauge 3 times | 5-20N |
| Disconnection Force | After connecting and disconnecting using standard plug gauge 3 times | 8-20N |
| Terminal Strength | Static load of 0.1N/m (1kgf/cm) applied to tip for 1 min in any direction | No damage, cracks, looseness or play; mechanical and electrical characteristics satisfied. |
| ELECTRICAL |
| Contact Resistance | Measured at small current (100mA or less) at 1000Hz | 40m MAX |
| Insulation Resistance | Apply 100V DC for 1 min to specified portions | 100M MIN |
| Dielectric Strength | AC 100V (rms, 50~60Hz) for 1 min, trip current: 0.5mA, applied to specified portions | No damage, arcing or breakdown. |
| DURABILITY |
| Solderability Test | Top of terminals dipped 1mm in solder bath at 2505 for 50.5 seconds | Solder wetting time 3 sec; Soldering area > 75% |
| Resistance to Soldering Heat Test (Reflow) | Preheat: 180, 120s; Peak temp: 2605 within 20s | No deformation of case or excessive looseness of terminals; electrical characteristics satisfied. |
| Resistance to Soldering Heat Test (Soldering Iron) | Bit temp 3305, application time 30.5 sec, no excessive pressure | No deformation of case or excessive looseness of terminals; electrical characteristics satisfied. |
| Humidity Test | Stored at 402 and 90% to 96% humidity for 96 Hr, then 1 Hr at standard atmospheric conditions | Appearance and characteristics satisfied. |
| Heat Test | Stored at 702 for 96 Hours, then 1 Hr at room temperature | No damage on appearance; mechanical and electrical characteristics satisfied. |
| Cold Test | Stored at -253 for 96 Hours, then 1 Hr at room temperature | No damage on appearance; mechanical and electrical characteristics satisfied. |
| Life Test (Without Load) | 5000 cycles (insertion/extraction) at 10 to 25 cycles/min | Mechanical and electrical characteristics satisfied. |
| Life Test (With Load) | Rating condition (non-inductive load), 5000 cycles at 10 to 20 cycles/min | Contact Resistance 0.1; Disconnection Force 0.8 to 2.0N; Mechanical and electrical characteristics satisfied. |
| Temperature Cycling Test | 5 cycles as per figure, then 30 min at room ambient | No deformation or cracks in molded part; Insertion & Extraction Force: 3 to 20N; Contact Resistance: Max.30m; Insulation Resistance: Min.100 M; Dielectric Withstanding Voltage: 100VAC/min (between terminals). |
| Cold & Heat Shock Test | 5 cycles as per figure, then 30 min at room ambient | No deformation or cracks in molded part; Insertion & Extraction Force: 3 to 25N; Contact Resistance: Max.30m; Insulation Resistance: Min.100 M; Dielectric Withstanding Voltage: 500VAC/min (between terminals). |
